| The switch of ignition and the wheel lock |
| 1. Look subsection 12.10. |
| Combination of switches on a steering column |
| 2. Remove overlays of a steering column. |
|
|
| 3. Remove the necessary switch from an arm (a photo at the left), having submitted on itself, having opened a socket (a photo on the right). |
| 4. The switch is established upside-down. |
| Push-button switches in an average part of the forward panel |
|
5. Remove an average part of the panel. |
| 6. Disconnect sockets from switches. |
|
7. Submit the switch forward and get. |
| 8. Assemblage is carried out upside-down. |
| The switch of the fan of a heater |
| 9. Remove the control panel a heater (subsection 5.1.1 see). |
| 10. Get the handle of management of the fan. |
| 11. Release latches (two below and one above) and get the switch. |
| 12. Establish the switch upside-down. |
| Switches from outside the driver |
| 13. The switch of a drive of a mirror, illumination of the panel of devices, forward antifog headlights concern these switches. |
| 14. Remove a casing of the panel of devices with a ventilating nozzle. |
| 15. Working under the panel, release latches and get the switch. Disconnect a socket. |
| 16. At assemblage insert the switch before click. Establish a casing of the panel of devices with a ventilating nozzle. |
| The electric drive switch стеклоподъемника |
| 17. Hook and get the switch and disconnect a socket. The socket fastens скобой from within, therefore it can be necessary to remove the door panel. |
| 18. Establish the door panel, insert the switch before click. |
| The switch of a drive of the hatch |
| 19. Cautiously, having wound an edge of a thin screw-driver PHV - a tape, hook the switch which is in the case of a drive of the hatch. |
| 20. Disconnect a socket and get the switch. |
| 21. Assemblage is carried out upside-down. |
| Trailer switches of the alarm system of leaky closed door / of a plafond of illumination of a door |
| 22. Open a door. The switch is on a forward rack of a doorway. |
| 23. Turn away screws and get the switch, disconnect a socket. |
| 24. Establish the switch upside-down. Check up correctness of installation of a sealant. |